1-800-566-3474

JG 1/4 inch x 1/4 inch Union Connector - White

Read 1 Reviews Write a Review

In Stock: Order by 2PM EST for same-day shipping (M-F)

This item is in stock in our East and West Coast warehouses

$3.49 $3.69
You Save: $0.20 (5%)


RO5151

Add to Wishlist

SHIPS FREE!

John Guest

Color: White
John Guest Part# : CI0408W
Tube O.D.: 1/4"
Tube O.D.: 1/4"
Drill Hole size: 0.67 in

How to make a connection

  • Cut tube square
    It is essential that the outside diameter be free of score marks and that burrs and sharp edges be removed before inserting into fitting. For soft or thin walled plastic tubing we recommend the use of a tube insert.
  • Insert tube
    Fitting grips before it seals. Ensure tube is pushed in to the tube stop.
  • Push up to tube stop
    Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the "O" ring provides a permanent leak proof seal.
  • Pull to check secure
    Pull on the tube to check it is secure. It is good practice to test the system prior to leaving site and/or before use.
Disconnecting
Push in Collet and remove tube

To disconnect, ensure the system is depressurized before removing fitting. Push in collet squarely against face of fitting. With the Collet held in this position, the tube can be removed. The fitting can then be re-used.


Manufacturer Info

John Guest
In 1961 John Guest`s vision was to run a company with innovation, quality and sustainable growth to be at the core of the organization’s principles.

In 1974, John Guest developed his first push in tube connector for use with compressed air. That basic "Super Speedfit" concept has been developed to include fittings for a wide range of applications.

John Guest`s World Headquarters are located in the UK where all their fittings are designed, manufactured and distributed throughout the world.

SEAN from CULVER CITY, CA

06/24/2012

Experience Level: Intermediate

good high pressure connector

Used this connector with new RO/DI system. Quick and easy to connect and disconnect. RO/DI has about 75psi in the system and not a single leak with over 20 connections, just be sure to use a sharp razor to cut the tube ends square.

0 out of 1 found this review helpful

Was this review helpful?