D-D ROWA Calcium Reactor & Kalkreactor Media |
|
Calcium Reactor Media |
D-D ROWAlith C+ is the recommended media for Deltec Fluidised Calcium reactors and is 50:50 blend of Rowalith C and Rowalith W.
Instructions for use of D-D ROWAlith C+:
This material must be washed very very thoroughly before placing inside your Fluidized Reactor, if you do not do this the reactor will run cloudy.
ROWAlith-C is a natural material specially chosen to produce the highest calcium output in your Fluidized Reactor.
Set the reactor to run between 30 to 40 dKH. Measure the water from the reactor after allowing it to run for 24 hours, from the output flow.
Due to the efficiency of the fluidized reactor constant top up of this material will be required. Please ensure that the calcium levels in your aquarium do not exceed 480 to 500 mg/l.
For saltwater only. |
 |
|
|
|
Kalkreactor Media |
D-D ROWAkalk has long been known in a reef aquariums that the inhabitants are constantly in need of calcium to build their skeletons and shells. Administering ROWAkalk to your aquarium will enhance pH as well as binding phosphates, therefore enhancing protein skimming. ROWAkalk is the ideal supplement mix for producing kalkwasser.
Calcium hydroxide should only be administered after the calcium hydroxide (kalkwasser) mix has cleared. The cleared and fresher the solution, the better the results. Mechanical stirrers are highly recommended to dose kalkwasser.
To obtain the best results, you should use DO or RO water. Dosing should take place at the lowest point of the pH cycle. This normally being at night approximately 5 to 6 hours after the light have been turned off. Attention should be paid to the pH when dosing as it could rise to dangerous levels if administered to fast.
The pH of calcium hydroxide when first mixed in RO or DI water should be 12.45. The marine aquarium environment should never have a pH exceeding 8.5 and when over dosing kalkwasser, this could be exceeded if care and attention is not paid. |
 |
|
|