| # of Drops |
mg/L (ppm)
Calcium(Ca2+) |
# of Drops |
mg/L (ppm)
Calcium(Ca2+) |
| 1 |
20 |
14 |
280 |
| 2 |
40 |
15 |
300 |
| 3 |
60 |
16 |
320 |
| 4 |
80 |
17 |
340 |
| 5 |
100 |
18 |
360 |
| 6 |
120 |
19 |
380 |
| 7 |
140 |
20 |
400 |
| 8 |
160 |
21 |
420 |
| 9 |
180 |
22 |
440 |
| 10 |
200 |
23 |
460 |
| 11 |
220 |
24 |
480 |
| 12 |
240 |
25 |
500 |
| 13 |
260 |
26 |
520 |
|
Specifications
Testing Tips:
The Calcium Test Kit reads the calcium concentration in milligrams per liter (mg/L) which is equivalent to parts per million (ppm).
Directions:
- Read thoroughly before testing. Do not allow test solutions to get into aquarium.
- To remove childproof safety cap: With one hand, push red tab left with thumb while unscrewing cap with free hand.
- Rinse a clean test tube with the water being tested.
- Fill the test tube to the line with the water being tested.
- Holding the bottle vertically, add 10 drops of Calcium Test Solution #1 to the test tube, cap and shake for 10 seconds.
- Shake Calcium Test Solution #2 bottle vigorously for 10 seconds.
- Holding the bottle vertically, add Calcium Test Solution #2, drop by drop to the test tube until the solution changes from pink to the blue end-point. Each drop is equivalent to 20 mg/L (ppm) calcium (Ca2+). Cap and shake the test tube between drops. Be sure to count the drops added.
- A pink color should form after the first drop.
- If a blue color forms after the first drop, the calcium concentration is 20 mg/L (ppm) or below.
- As the end-point is approached, the color will usually change from pink to purple before finally changing to blue. After the purple color forms, only one or two more drops should be required to reach the blue endpoint.
Note: Reef aquariums should have a calcium (Ca2+) concentration of between 400 to 500 mg/L (ppm). To save time, rather than adding only one drop at at time, several drops of Calcium Test Solution #2 may be added simultaneously at first, then the final drops can be added drop by drop as the endpoint is approached.
For example, if you think that the saltwater being tested contains about 400 mg/L (ppm) calcium, you can add |