3’ Male/Male AquaBus cable. Used to connect an AquaBus module (PM1, EB8, etc) to another AquaBus Module or Apex base unit.
The RLSS Waveline Interface cable will allow you do connect your Apex-Ready Waveline DC pump to the VDM (variable dimming module) Ports of your Neptune Systems Apex Controller.
Once connected, you can easily program your Apex ...
2 Channel AquaSurf or Apex to stream cable assembly. It has 1 RJ45 connector which plugs into the Apex base unit, and 2 Din5 connectors which plug into 2 Tunze Controllable Stream pumps.
Digital Aquatics pH Calibration Kit Included:
2 x 7.0 pH packets
2 x 10.0 pH packets
15’ Male/Female AquaBus cable. Extension Aquabus cable used to lengthen AquaBus cables so that modules which are more than 15’ apart can be connect together.
American Marines Wireless Thermometer Sensor Utilizing a radio wave signal, the remote sensor(s) will measure the temperature at the waterproof probe tip and send the information to the PINPOINT Temperature Display Monitor, which...
120V AC to 12V DC Power Adapter for use on the AquaController Apex.
Very handy for UPS setups or firmware updates.
Advanced LED Dimming Cable for Apex VDM Module
Use this cable to connect Aqua Illuminations Sol and Acan Lighting LEDs to the VDM Module
You can have complete control over your AI Sol and supported Acan Lighting LED Ligh...
Combination stream and light dimming cable for Apex variable speed ports. It has 1 RJ45 connector on one end of the cable which plugs into the Apex base unit. The other end of the cable contains 1 Din5 connector used t...
1 bottle each of 1 ppm, 10 ppm and 100 ppm nitrate calibration fluids.
DC24 to Bare wire cable - 10’
For the DIY hobbyists out there. This cable connects to the 24VDC accessory connections on the 1LINK module. This cable has two bare (tinned) wires on the other end so you could connect it up to a ...
1LINK Male - Male cable - 10’
4-pin male to male cable many hobbyists have been waiting for. It is ten feet long. This cable allows you to connect your DOS to the 1LINK thereby eliminating the need for the DOS to be connected t...
1 bottle each of 100 ppm and 1,000 ppm calcium calibration fluids. The calcium monitor fluid kit is used to re-calibrate your PinPoint Calcium Monitor. It can also be used to validate the readings from your calcium test kits...
This 9-foot control cable allows for connection between the Neptune Apex controller and the Basic models of the Aquatic Life Halo LED Pendant Fixture (Both Freshwater & Marine)
This 9-foot control cable allows for connection between the Digital Aquatics Archon controller, or the ALC module for the ReefKeeper, and the Aquatic Life Basic models of the Halo LED Pendant Fixture (Both Freshwater & Marine)