Kit includes Lumatek 250W Multi-Wattage Ballast and 15-foot Lumatek Quick-Disconnect Lamp Cord
Lumatek 250 Watt 120V/240V Multi-Wattage Ballast
The Lumatek Digital Ballast is the brightest ballast in the industry. Light meter readings indicate that the Lumatek ballast is up to 27% brighter than common core and coil magnetic ballasts. The Lumatek is 10-15% brighter than other brands of digital ballast on the market.
- Dimmable Electronic Ballast
- Dual-Voltage - The only E-Ballast with the same light output on 120V or 240V
- Multi-Wattage – Powers 150W, 175W, 250W and HQI Lamps
- The HQI setting on the 250 Watt Ballast provides 10% MORE Light!
Over time, core and coil ballasts will degrade, become louder, use more electricity, and produce more heat, while the lumen output declines. Digital ballasts maintain lumen output and efficiency over the life of the unit. The output of magnetic ballasts degrades over time and can fluctuate by up to 10% during a 12 hour cycle. Digital ballasts produce a constant output without any fluctuation.
Magnetic ballasts waste up to 75 watts to convert the electricity, whereas Lumatek sends the FULL 250 watts to the bulb, lighting it to its fullest potential. The Lumatek achieves superior light meter readings in comparison with other digital ballasts on the market through using microprocessors to detect the precise type of lamp used and accordingly supply the correct power. Some lamps are able to use slightly more than 250 watts. The Lumatek ballast will detect this difference and increase output accordingly.
Electronic Ballast vs E-Ballast
The Lumatek ballast is an E-ballast, unlike other brands on the market, which are actually electronic ballasts. E-ballasts use a microprocessor similar to a component found in a personal computer. This microprocessor allows the E-ballast to run either halide or sodium lamps, to switch between 50 and 60 hertz, to make adjustments for the type of bulb it is running, and even to compensate for degraded lamps by increasing its output. Electronic ballasts have a constant output and cannot make adjustments or changes. They will light a MH lamp; but quickly cause it to degrade, thus shortening the lamp`s lifespan.
Lumatek ballasts are programmed to allow for a `soft start` and do not require an initial power surge to start the ballast. This allows end users to start multiple ballasts simultaneously without blowing a breaker. The ballast will also detect a short in the wiring or a defective lamp. It simply shuts itself off, letting the user know that something is wrong. This should be kept in mind if you have a customer whose ballast keeps shutting down. In most cases, there is a problem with the output wiring.
All digital ballasts produce the same amount of heat due to the total heat output. Do not be fooled by inferior units that use fans. These fans do not make the units run cooler. They simply exhaust the heat into the room. Each unit is tested at the factory for 12 hours with the lamp 6 inches from the unit. We are currently testing a new Mosfet that will lower the running temperature of the 120v unit. The Mosfet is the power supply circuit. It transforms the input electricity to the correct current and voltage for the ballast. This is the most important part of the electronic ballast and makes a huge performance difference.
RF Shielded Output Cord
The Lumatek ballast comes with an attached 15ft. RF shielded output cord. Competing brands of digital ballasts which do not employ shielded cords can seriously disrupt radio and satellite TV signals for up to 50 yards. This interference may also disrupt the operation of pH equipment. The Lumatek ballast, if properly connected, will have minimal RF interference at less than 5 ft. and will not interfere with pH equipment. In order to ensure maximum RF shielding, the output cord must be wired directly to the socket. If the ballast is connected to an existing unshielded wire, it will cause radio and satellite television interference. Both ground wires should be grounded to the socket set for maximum RF interference suppression. If it is necessary to extend the output cord further than the 15ft. supplied, the customer should purchase RF shielded wire to lengthen the output cord.
Lumatek offers the best warranty in the industry, 3 - year replacement and 2 - year pro-rated. Lumatek will replace any defective units with brand new units for 3 years from the date of purchase. Please retain the original receipt from the place of purchase. A copy is required for all warranty issues. Also, these units should not have been modified or physically damaged. During the fourth and fifth year, Lumatek will supply the customer a pro-rated replacement ballast.
There are several Lumatek look-alikes on the market. Do not assume that these have the same exclusive quantity and performance as the Lumatek. They typically use inferior components and technology and are not true E-ballasts.
The Lumatek Ballast is the brightest in the industry. Light meter readings indicate the Lumatek is up to 27% brighter than common magnetic ballasts and 10 - 15% brighter than competing electronic ballasts. Over time, magnetic ballasts degrade, become louder, use more electricity, and produce more heat, while the lumen output declines. Digital ballasts do not degrade and maintain their lumen output and efficiency over the life of the unit.
The Lumatek is not just your standard electronic ballast, but is a more advanced E-Ballast. What is the difference? E-Ballasts use a micro-processor similar to your home computer. This micro-processor allows the E-Ballast to run halide or sodium lamps, make adjustments based on the type of lamp it is running, and will even compensate for degrading lamps by increasing output. Electronic ballasts have a constant output and cannot make adjustments or changes. There are plenty of other digital ballasts on the market, do not assume they are all the same. Typically they use inferior components and are not true E-Ballasts.
The Lumatek is programmed for a `soft-start` and does not require an initial surge of power to light the lamp. This increases the lamp life and allows the end user to start multiple ballasts at the same time without tripping breakers. To ensure safe operation, the Lumatek is programmed to automatically shut off in case of a short in wiring or a faulty or missing lamp.
The Lumatek uses a resin-sealed case for completely silent operation without a noisy fan. Each unit is burned in at the factory for twelve hours to ensure maximum reliability. The Lumatek comes with a 15ft. RF shielded output cord. Competing brands of digital ballasts not using shielded cords can disrupt radio or satellite signals for up to 50 yards. The same interference can also be experienced with pH monitoring equipment. The Lumatek ballast, if properly connected, will have minimal RF interference (less than 5 ft.) and will not interfere with pH monitoring equipment.
The best Electronic Ballasts money can buy...
More power, more lumens more blooms......
Lumatek is the worlds leading supplier of Electronic Ballasts to horticulture. With the arrival of Electronic Ballasts, a technological revolution has taken place in energy efficiency for HID lighting. This replacement of magnetic ballasts (a technology more than 100 years old) with electronic HID ballasts is because of the proven efficiency gains. Tests have shown that Lumatek ballasts are up to 30% brighter than some old style magnetic ballasts. Independent laboratory tests have proven that Lumatek ballasts are more efficient than any magnetic ballast known to Lumatek. This means more lumens are produced per watt of energy consumed.
Lumatek is the number one supplier of Electronic Ballast to the hydroponics and horticultural industries worldwide, and is proudly available in at least 13 countries. Lumatek products are sold into government research facilities, major nurseries, top universities and numerous publicly traded companies. This makes the Lumatek range the most proven product in the market, in addition we have the industries best warranty with 5 years covered (3 years full and two years pro-rated).
Lumatek Electronic Ballasts: proven technology
We ship 99% of the products we carry for free within the contiguous United States using a mix of economy methods including USPS First Class Mail, SurePost and UPS Ground. Your order will arrive in 5-7 business days.
Over 90% of our members receive their orders within 2 business using UPS Ground. Upgrade from free economy shipping to UPS Ground for only $4.99—or spend $299 and we’ll upgrade you automatically!
Expediated shipping services are available for most products if you are in a hurry. Get guaranteed delivery in 2 business days, 1 business day, or next day by 10:30 am. Costs vary by location.
Same-day shipping is available Monday-Friday for most products—place your order by 10 am PST. Pre-ordered and back-ordered items do not qualify, nor do drop-shipped, live, or frozen shipments.
We ship live plants, live foods, and frozen foods within the contiguous United States. Each of these categories is subject to its own $19.99 flat-rate shipping fee to cover the special packaging and/or expedited shipping costs required to ensure safe delivery. Orders with 12+ live plants ship free!
Learn More About Shipping
Return any new and unused item within 60 days for a full refund. Having difficulty with a product? Contact us to speak with an aquarium expert. If you need a replacement, fill out this form.
A small segment of the 180+ brands we carry require that customers contact them directly if/when problems arise. You can view the full list of those brands and get their contact info here.
Marine Depot is an authorized reseller for every product we carry. That means when you buy aquarium supplies from us, your products are not only backed by our own 60-day return policy, they also carry full factory warranties, where applicable. Some items have a 1-year warranty, others have limited lifetime warranties. Warranty coverage varies from manufacturer to manufacturer, so please read the product description of the item(s) you are considering thoroughly for details or contact us if you have warranty questions.
Learn More About Returns
Rack up reward points to earn discounts on future purchases! You can earn reward points by creating an account, writing reviews, referring friends, subscribing to our newsletter, buying products, and more!
- Earn 5 reward points for every $1 you spend to get 5% cash back
- Earn 1 reward point for every $1 you spend to get 1% cash back
AquaIllumination, CoralVue, Digital Aquatics, EcoTech Marine, IceCap, Innovative Marine, Kessil, Korallen-Zucht, Maxspect, Nano Box, Neptune Systems, NYOS, Oceanbox Designs, Pax Bellum, Red Sea, Reef Glass, Reef Octopus, Somatic, and Vertex Aquaristik
You can also get bonus reward points by purchasing select items during special sales and promotions.
Learn More About Rewards